Introducing the GRT 2.0 - Glock Reset Trigger!
This forced reset trigger is compatible with all Gen 1-4 Glock handguns and Glock clones.(Will not work in .22lr Glock models!)
The GRT 2.0 is a partially skeletonized, textured, flat face, one-piece forced reset trigger manufactured using 316 stainless steel.
Installing this one-piece forced reset trigger on a Glock or Glock clone is a quick and simple process:
Preparation & Disassembly
- Clear the firearm: Verify the chamber is empty, remove the magazine, and field-strip the slide from the frame.
- Remove pins: Punch out the rear frame pin and the trigger housing pin, then pull out the locking block and trigger assembly.
- Strip the bar: Punch out the pin holding the factory trigger shoe to the trigger bar.
GRT Installation
- Mount the trigger: Align the GRT onto the trigger bar.
- Secure the pin: Drive a secure 2x8 roll pin through the trigger shoe and bar to lock it firmly in place. Stainless steel roll pins are recommended.
- Reinstall housing: Drop the completed trigger assembly back into the frame and finish reassembling the handgun.
Tuning Tips
- Check compatibility: Gen 5 or slimline models are not officially supported and may require swapping to an older-generation slide release or adjusting component compatibility to retain slide-stop features. On Gen 5 models, the ambi slide release can be swapped for the single side slide release from previous generations.
- Polishing recommended: Manual polishing of your GRT and trigger bar is recommended.
- Additionally, a careful "25 cent trigger job" is always recommended!
- Recommended Parts: It is recommend to use a 3-3.5 lb connector, and depending on your setup, a high power recoil spring.